Overview
The Amplifier Research 30W1000A is a portable, self-contained, air-cooled, broadband, solid state amplifier designed for applications where instantaneous bandwidth and high gain are required. Push-pull circuitry is utilized in the high power stages to lower distortion and improve stability.
The 30W1000A, when used with an RF sweep generator, will provide a minimum of 30 watts of swept power. Included is a front panel gain control which permits the operator set the desired output.
The 30W1000A is protected from RF input overdrive by limiting diodes and an RF input leveling circuit which controls the RF input level to the RF amplifier first stage when the RF input level is increased above 0 dBm. The RF Amplifier stages are protected from over temperature by removing the DC voltage to them if an over temperature condition occurs due to cooling blockage or fan failure. There is a digital display on the front panel to indicate the operate status and fault conditions when an over temperature, power supply, or amplifier fault has occurred. The unit can be returned to operate when the condition has been cleared. The 30W1000A includes digital control for both local and remote control of the amplifier. This 8-bit RISC microprocessor controlled board provides both IEEE-488 (GPIB) and asynchronous, full duplex RS-232 control of all amplifier functions.
Applications
Typical applications of the Amplifier Research 30W1000A include antenna and component testing, wattmeter calibration, EMI susceptibility testing, as a driver for frequency multipliers, and as an RF source for magnetic resonance imaging studies.
The Amplifier Research 30W1000A is in stock and available for same-day shipping on rentals. The EMC Shop is an ISO 17025 accredited calibration lab. Calibrations are available upon request (allow 1-2 additional days).
