ISO 16750-2

Go straight to our available test equipment for ISO 16750-2.

This part of ISO 16750-2 requires electric and electronic systems/components in road vehicles to apply potential environmental stresses and specifies voltage disruptions and transients. The current edition of ISO 16750-2 saw updates to every test, aligning with UN ECE R10.

REQUIRED TESTS

  • Direct current supply voltage
  • Overvoltage
  • Superimposed alternating voltage
  • Slow decrease and increase of supply voltage
  • Discontinuities in supply voltage
  • Reversed voltage
  • Ground reference and supply offset
  • Open circuit tests
  • Short circuit protection
  • Withstand voltage
  • Insulation resistance
  • Electromagnetic compatibility

ISO 16750-2 EDITION 5 (2023) TEST ADDITIONS

  • introduction of use of operating mode for the electrical tests
  • introduction of concept with redundant supplies for relevant test cases
  • introduction of transient overvoltage test
  • introduction of micro interruption in supply voltage test

As well as a complete update of superimposed alternating voltage test (e.g. updated test method, extension of frequency range to 200 kHz, etc.)

ADJUSTABLE WAVEFORM PARAMETERS
IN MOST TEST EQUIPMENT

ISO 16750-2 Load Dump Test Waveform

TEST SETUP

ISO 16750-2 references EMC specifications but there is no defined test setup or environment as they aren't considered electromagnetic compatibility tests.

Performance measurements from the referenced EMC standards are not included in the scope of the ISO 16750 series.

ISO 16750-2 TEST EQUIPMENT

Using AWG from 3ctest with LDS, TIS and APS Systems.

SAME DAY SHIPPING

The EMC Shop specializes in the electrical stress testing according to ISO 16750-2 and other test standards for electric vehicles, batteries, and charging stations.

ISO 16750-2 Test Equipment