MIL-STD-461 CS101

(Showing 10 of 10)

The EMC Shop stocks test equipment to perform MIL-STD-461 CS101 testing.

MIL-STD-461 CS101 Purpose

Conducted Susceptibility Testing on Power Lines, 30 Hz to 150 kHz

 

This test procedure is used to verify the ability of the EUT to withstand signals coupled onto input power leads. There are two methods provided for making measurements of the applied signal. The first uses an oscilloscope with a power input isolation transformer. The second uses a measurement receiver together with a transducer. The transducer is intended to electrically isolate the receiver from the EUT power and reduce the signal levels to protect the receiver.

MIL-STD-461 CS101 Test Setup

MIL-STD-461 CS101 Test Setup

The test equipment required:

  1. Signal generator
  2. Power amplifier
  3. Oscilloscope or measurement receiver
  4. Coupling transformer
  5. Capacitor, 10 μF
  6. Isolation transformer
  7. Resistor, 0.5 ohm
  8. LISNs
  9. Transducer for measurement receiver

Test Now

The EMC Shop stocks equipment for MIL-STD-461 CS101 testing.

MIL-STD-461 CS101 Test Equipment, Systems & Solutions

Connect with The EMC Shop

Our experienced staff can help you with applications, purchase and rental options.