Conducted Immunity

(Showing 12 of 54)

Rent buy or lease conducted immunity test equipment for pre-compliance and certification. The EMC Shop specializes in RF, electrical transient and other electromagnetic compliance test standards.

 

Verifying your products vulnerability to unexpected electrical transients was once a tedious task and often overlooked. Manufacturers sending their DUT's to test labs only to be sent back not conforming. With pre-programmed scripts for most commercial and military standards, many firms are bringing the capability in house, allowing engineers to hook up and auto run the test to meet IEC, Mil-Std, ISO, CE marking and more.

Show 12 24 36 48
  • EMC Partner

    EMC Partner CDN-KIT1000 ED3

    Standard: IEC 61000-4-5
    Application: surge on 2 unsymmetrical lines
    Test level surge: max. 6 kV
    EUT voltage per line: max. 200 V DC or 240 V peak
    EUT current per line: max. 4 A cont. or 5 A for 5 min.
    Typically In Stock
  • EM Test

    SKU: sku-2169

    EM Test Surge, EFT, PQF, Ring Wave Immunity System for 3 Phase, 100 Amp EUT

    Test Capabilities: Combination Wave Surge Immunity , EFT/Burst, Dips Interrupts, Ring Wave
    Standards Met: IEC/EN 61000-4-4, IEC/EN 61000-4-5, IEC/EN 61000-4-11, IEC/EN 61000-4-12 IEC/EN 61000-4-29
    Applications: CE Marking, Medical Devices, Industrial Machinery, Electronics & IT
    Max EUT AC Voltage (w/ Built in CDN): 480 Volts
    Max EUT AC Current (w/ Built in CDN): 100 Amps (Per Phase)
    Max EUT DC Voltage (w/ Built in CDN): 1000 Volts
    Max EUT DC Current (w/ Built in CDN): 100 Amps
    Peak inrush current capability: 500 Amps
    EFT/Burst Pulse Output Capability: 5.5 kV
    Combination/Wave Surge Output Capability: 6.6 kV
    External Coupling: Data Lines (EFT & Surge)
    Dips & Interrupts: 40%, 70%, 80%; Interrupts - 0% (short and open)
    Ring Wave: 100 kHz, 6 kV
    RENTAL ONLY
  • SKU: sku-2132

    EMIC-35 Current Injection Clamp for RF Conducted Immunity Testing

    Weight: approx. 14 kg
    Application/Test Type: Injects the disturbance signal through a combination of inductive and capacitive coupling
    Clamp factor (CF): -.6 dB at 100 kHz to -2.2 dB at 1 GHz (Min -4 dB at 700 MHz
    Connector: N-type female
    Dimensions: 666 mm x 135 mm x 120 mm
    Frequency Range: 10 kHz to 1000 MHz
    Impedance: 50 Ohms
    Max. Cable Diameter: 35 mm
    Maximum Continuous Power: 0.15 to 100 MHz: 100 W for 15 min; 100 to 230 MHz: 100 W for 5 min; 230 to 1000 MHz: 50 W for 3 min
    Standards Met: IEC/EN 61000-4-6; CISPR 24; EN 61000-6-1; EN 61000-6-2; IEC 60533; IEC 60601-1-2; IEC 61326
  • EM Test

    SKU: sku-1195

    Complete IEC/EN Test Rack for CE Marking and Conducted Immunity Certification

    Test Capabilities: Combination Wave Surge Immunity , EFT/Burst, Dips Interrupts & Variations
    Standards Met: IEC/EN 61000-4-4, IEC/EN 61000-4-5, IEC/EN 61000-4-11, IEC/EN 61000-4-29
    Applications: CE Marking, Medical Devices, Industrial Machinery, Electronics & IT
    Max EUT AC Voltage (w/ Built in CDN): 264 Volts
    Max EUT AC Current (w/ Built in CDN): 16 Amps
    Max EUT DC Voltage (w/ Built in CDN): 220 Volts
    Max EUT DC Current (w/ Built in CDN): 10 Amps
    Peak inrush current capability: 500 A (at 230 V)
    EFT/Burst Pulse Output Capability: ±200 V to 4.8 kV (in 1 V steps) - open circuit±100 V to 2.4 kV ±100 A to 2.2 kA
    Combination/Wave Surge Output Capability: ±200 V to 4.4 kV (in 1 V steps)
    External Coupling: Data Lines (EFT & Surge), 3PH EUT
  • Thermo Keytek

    SKU: sku-1054

    Thermo Keytek EMCPro Plus EMC Immunity Test System

    Test Capabilities: Combination Wave Surge Immunity, EFT/Burst, Dips Interrupts & Variations
    Applications: CE Marking, Medical Devices, Industrial Machinery, Electronics & IT
    Max EUT AC Voltage (w/ Built in CDN): 250 Volts
    Max EUT AC Current (w/ Built in CDN): 16 Amps
    Max EUT DC Voltage (w/ Built in CDN): 100 Volts
    Max EUT DC Current (w/ Built in CDN): 10 Amps (16A @ 48 VDC)
    Peak inrush current capability: 500 Amps (up to 3kA at 2 Ohms)
    EFT/Burst Pulse Output Capability: 4 kV
    Combination/Wave Surge Output Capability: 6 kV
    External Coupling: Data Lines (EFT & Surge)
    Dips, Interrupts & Variations: 40%, 70%, 80%; Interrupts - 0% (short and open)
    Ring wave: 100 kHz Damped up to 6 kV/500A
    $1,695.00
    In Stock
  • EM Test

    SKU: sku-921

    Monthly Rental EM Test CWS 500N Continuous Wave Simulator for IEC 61000-4-6

    Weight: 17 kg (37.5 Pounds)
    Application/Test Type: Create and output RF currents as well as measure input for CDN and clamp calibration as well as current monitor for clamp applications
    Dimensions: 19"/3 HU
    Frequency Range: Sinus (CW) 100kHz to 300MHz Frequency bands 100kHz to 9.999MHz 10MHz to 99.99MHz 100MHz to 300MHz
    Impedance: 50 Ohms
    Input: 115 V to 230 V +10/-15 %, 50/60 Hz (380 Watts Max)
    Maximum Continuous Power: 80W (nominal)
    Standards Met: IEC 61000-4-6
    Test Routines: Quick Start, User Test Routines, Standards Test Routines (IEC/EN 61000-4-6), Cal Procedure, Service
    Voltage Rating: 1 V to 30 Volts Max
  • EM Test

    SKU: sku-817

    EM Test LD 200N Load Dump Generator for ISO 16750-2

    Output: +/- output Safety laboratory connectors Coupling To the battery +lineDecoupling Via diodeDUT supply Max. 80V/30A
    Freestyle Mode Micropulses: Rise time 1us 10us - 90us with 10us steps 100us - 900us with 100us steps 1ms - 10ms with 1ms steps Pulse duration 10ms - 1,200ms Int. resistor 0.5ohm - 38ohm, in steps of 0.1ohm
    Test Standards: ISO 7637-2 Pulse 5b for 12V and 24V, ISO/WD 16750 Pulse 5b, and much more
    Test Routines: Quick Start, User Defines Routines, Standards Test Routines Service
    $1,690.00
    Typically In Stock
  • Thermo Keytek

    SKU: sku-801

    Thermo Fisher Keytek ECAT High Voltage Burst/EFT Generator up to 8 kV

    Burst (EFT) 5/50 ns: Pulse conforms to IEC/EN 61000-4-4
    Burst frequency: Adjustable from 1 kHz to 1 MHz up to 4.4 kV; 1 kHz to 250 kHz from 4.4 kV to 8.0 kV
    Burst time: 1 to 360 sec.; 1 second resolution 1 to 240 min.; 1 minute resolution 1 to 24 hours; 1 hour resolution
    Polarity: Positive, negative, alternating
    Pulse amplitude: 200V to 8.0kV, ±10%; 5 V resolution
    Standards Met: IEC 61000-4-4, IEC 61000-4-5, IEEE C62.41, UL 864, ANSI/IEEEC62.41, UL 1449
    In Stock
  • SKU: sku-785

    Turn-Key Solution for EFT/Burst, Surge Combination Wave with 3-Phase CDN and EFT Clamp up to 5 kV

    Phase synchronization: 0° - 360°
    Polarity: positive / negative / alternate
    Application/Test Type: Complete CE Mark Solution
    Burst (EFT) 5/50 ns: Pulse conforms to IEC/EN 61000-4-4
    Burst frequency: 1 Hz – 1,000 kHz
    Combination wave pulse 1, 2/50 - 8/20 μs (Hybrid-Surge pulse): Pulse conforms to IEC/EN 61000-4-5
    Coupling: Included
    Event time: unlimited
    Phase synchronization-2: – 359° with 1° steps or asynchronous mode
    Polarity-2: positive / negative / alternate
    Pulse amplitude: 0.2 – 5.0 kV
    Pulse current (short circuit): 0.1 – 2.5 kA ±10% (8 us ±20% risetime)
    Pulse repetition: automatic 2 s – 100 min (Manual and external triggering available)
    Pulse voltage (open circuit): 0.2 – 5.0 kV ±10% (1.2 us ±30% risetime)
    Repetition time: 50 ns ±30% at 50 Ohm 50 ns –15 +100 ns at 1'000 Ohm
    Test duration: 0:01 min - 99:59 min or endless
  • Schloder

    SKU: sku-783

    Schloder CWG 1500 Surge Generator, 4.4 kV, 2.2 kA, EN/IEC 61000-4-5

    Condition (5-10 Scale): 9
    Warranty: 6 Months
    Calibration: Fresh w/ Data at Time of Order
    Test standard: IEC 61000-4-5
    Accessorries: Complete
    Input: 120VAC/1PH
    Phase synchronization: 0 - 359°, step 1° net sync. triggering
    Polarity: pos / neg / alternate
    Pulse current (short circuit): 0.1 - 2.2 kA
    Pulse voltage (open circuit): 0.2 - 4.4 kV
    Test duration: 10 - 990 sec
    $7,950.00
    1 LEFT
  • The EMC Shop

    SKU: TES-CE-Mark-RI-CI

    CE Mark Product Package for IEC/EN 61000-4 Series Compliance

    Industries: Medical Devices
    Combination wave pulse 1, 2/50 - 8/20 μs (Hybrid-Surge pulse): Pulse conforms to IEC/EN 61000-4-5
    Dips, Interrupts & Variations: Conforms to IEC/EN 61000-4-11, IEC/EN 61000-4-29
    Electrostatic Discharge: Pulse conforms to IEC 61000-4-2 edition 2
    Peak inrush current capability: greater than 500 Amps
    Pre-Programmed IEC Levels: Yes
    IN STOCK

Connect with The EMC Shop

Our experienced staff can help you with applications, purchase and rental options.