EMC Test Equipment

EMC Test Equipment Test Equipment, Systems & Solutions

• 

  Thermo Keytek E510A 10kV Surge Generator

  SKU: 10799

  Standards Met: ANSI/IEEE C62.41 Cat. B and IEC 61000 4-5

  Phase synchronization: ±15° with optional coupler/decoupler

  Pulse current (short circuit): 8/20µs, 0-5.05kA with 2 ohm effective source impedance, ±10%

  Pulse repetition: 1 shot/18 seconds

  Pulse voltage (open circuit): 1.2/50µs, 0-10.1kV ±10% in 1 volt steps

  Repetition time: Adjustable from 300ms to 5s; 1ms resolution

  Typically In Stock

  VIEW PRODUCT Cart

• 

  AH Systems TDS-535 Tuned Dipole Set, 25 MHz to 1 GHz, Receive and Transmit

  SKU: 10742

  Weight: 19 lbs.

  Antennas: Dipole Antennas

  Application/Test Type: precise EMI measurements

  Connector: N-type (female)

  Dimensions: Antenna Case: 28” x 23” x 7”

  Frequency Range: 25 MHz - 1 GHz

  Gain: Varies with Model

  Impedance: 50 ohm

  Inquire for Availability

  VIEW PRODUCT Cart

• 

  Amplifier Research 50T4G18, 50 Watts CW, 4.2–18GHz, (TWT) Microwave Amplifier

  SKU: sku-717

  Weight: 70 lbs, 32 kg

  Dimensions: 19.8 x 6.5 x 27 in., 50.3 x 16.5 x 68.6 cm.

  Flatness: ±10 dB maximum, 4.2 - 18 GHz

  Frequency Range: 4.2–18GHz

  Gain: GAIN (at maximum setting) ......47 dB minimum GAIN ADJUSTMENT (continuous range)......35 dB minimum

  Impedance: 50 ohms

  Input: 99-260 VAC

  Output: POWER (fundamental), CW, @ OUTPUT CONNECTOR Nominal .60 watts Minimum..50 watts Linear @ 1dB Compression..10 watts minimum

  RF Connector: Type N female

  RF Input Voltage: 1.0 milliwatt maximum for rated output

  VIEW PRODUCT Cart

• 

  3ctest CCC100 EFT/Burst Coupling Clamp for IEC/EN 61000-4-4

  SKU: 10621

  Application/Test Type: Electrical Fast Transients on Data Lines (EFT Burst)

  Cable Diameter: up to 40 mm (1.57 in)

  Coupling Length: 1 m (39.4 in)

  Dimensions: 1040x140x110mm

  EFT Coupling Clamps: as per IEC 61000-4-4

  RF Connector: High voltage connector,coaxial. GND connection 4 mm plug, banana

  Standards Met: IEC/EN 61000-4-4

  Voltage Rating: up to 5.5kv

  4 to 6 Weeks

  VIEW PRODUCT Cart

• 

  Haefely PSURGE 4010 Combination Wave Generator

  SKU: 10574

  Combination wave pulse 1, 2/50 - 8/20 μs (Hybrid-Surge pulse): Pulse conforms to IEC/EN 61000-4-5

  Coupling: Internal Single Phase/16 Amps at 264 VAC and 110 VDC -(expandable to 3-Phase with external module); 18uF and 9uF+10 Ω acc. to IEC 61000-4-5

  Polarity: positive, negative, alternating

  Pulse current (short circuit): 100 Amps to 2.1 kA

  Pulse repetition: up to 12 per minute

  Pulse voltage (open circuit): 200 Volts to 4.2 kV

  Standards Met: IEC 61000-4-5, EN 61000-6-1, EN 61000-6-2

  Industries: CE Marking, Medical Devices, Industrial Machinery, Electronics & IT

  Applications: Immunity to Electrical Surges (Test Setup)

  Typically In Stock

  VIEW PRODUCT Cart

• 

  Com-Power AM-741R Active Monopole Antenna with RAI-100, 9 kHz - 60 MHz

  SKU: 3525

  Weight: 9.5 lbs. [4.3 kg]

  Antenna Factor (1 Meter): ±0.5 dB

  Antennas: Monopole Antennas

  Application/Test Type: radiated emissions measurements, typically below 30 MHz.

  Connector: BNC (female)

  Frequency Range: 9 kHz to 30 MHz (useable to 60 MHz)

  Gain: See Image Thumbnail

  Impedance: 50 Ohms

  Mounting Base: 1/4" 20 thread

  Standards Met: Mil-STD 461,DO-160

  Cost New:

  Was:

  Price Now:

  $299.99 - $4,325.00

  In Stock

  ORDERING OPTIONS

• 

  Com-Power CGC-255E Comb Generator 50 kHz - 400 MHz in 50 kHz/250 kHz steps

  SKU: 11431

  Weight: 1 lbs / 0.5 kg

  AC Power Adapter: 6 VDC, 500 mA / 110VAC 60 Hz or 230 VAC 50 Hz

  Application/Test Type: Reference Signal Source for LISN verification

  Battery: 6V NiMH, 1 Ah

  Dimensions: 5 x 2.2 x 2.2 inches / 13.2 x 5.9 x 5.9 cm

  Frequency Range: 50 kHz to 400 MHz in 50 kHz or 250 kHz steps

  Mains & EUT Connections: LISN Interface Plug NEMA 15-P type

  Operation Time: 18 Hours Typical With Fully Charged Battery

  Inquire for Availability

  VIEW PRODUCT Cart

• 

  Haefely AXOS 8 7kV Surge & EFT Generator

  SKU: 10405

  Test Capabilities: Combination Wave Surge Immunity , EFT/Burst, Dips Interrupts & Variations

  Transient EMC Standards: IEC/EN 61000-4-4, IEC/EN 61000-4-5

  Power Fail EMC Standards: IEC/EN 61000-4-11, IEC/EN 61000-4-29

  Max EUT AC Voltage (w/ Built in CDN): 264 Volts

  Max EUT AC Current (w/ Built in CDN): 16 Amps

  Peak inrush current capability: 500 A (at 230 V)

  External Coupling: Data Lines (EFT & Surge), 3PH EUT

  Outputs: 4 mm banana socket

  Inquire for Availability

  VIEW PRODUCT Cart

• 

  Narda PMM COND-IS/10 RF Conductive Immunity Test System

  SKU: 11334

  Test Capabilities: RF Conducted Immunity

  Standards Met: IEC/EN 61000-4-6

  Applications: CE Marking, Medical Devices, Industrial Machinery, Electronics & IT

  CDN Test Levels (w/ built-in amplifier): 10Vrms

  BCI Test Levels (w/ built-in amplifier): 3V

  Frequency Range (w/ built-in amplifier): 150 kHz - 230 MHz

  Typically In Stock

  VIEW PRODUCT Cart

• 

  Thermo Keytek ECAT Transient Generator System

  SKU: 11321

  Pulse current (short circuit): Selectable at 200A max. or 500A max., when the open-circuit voltage is set to 6.0kV.

  Pulse repetition: 1 shot/9 seconds

  Pulse voltage (open circuit): 200V - 6.6kV ± 10%

  Ringwave 0.5 μs/100 kHz: Pulse conforms to IEC/EN 61000-4-12 and ANSI (IEEE) C62.41

  Standards Met: ANSI/IEEE C62.41 Cat. A and B, and various UL standards, including UL 864

  In Stock

  VIEW PRODUCT Cart

• 

  Pearson 411 Surge Current Monitor up to 5kA Peak Current, 1Hz to 20 MHz

  SKU: P-411

  AC Current Handling (DC-400Hz): 50 Amps

  RF Current Handling (CW/Pulse): 50/5,000 Amps

  Style: Fixed Window

  Diameter: 0.5"

  Transfer Impedance: 1 Ohm

  Test Standards: IEC 61000-4-5

  Frequency Range: 1 Hz to 20 MHz

  SEVERAL IN STOCK

  VIEW PRODUCT Cart

• 

  Teseq MD 101 ESD Pulse Measurement Target

  SKU: sku-33

  Inquire for Lead Time

  VIEW PRODUCT Cart