Conducted Immunity

(Showing 12 of 51)

Also See - Conducted Immunity Testing - Setup, Systems & More

Rent buy or lease conducted immunity test equipment for pre-compliance and certification. The EMC Shop specializes in RF, electrical transient and other electromagnetic compliance test standards.

Verifying your products vulnerability to unexpected electrical transients was once a tedious task and often overlooked. Manufacturers sending their DUT's to test labs only to be sent back not conforming. With pre-programmed scripts for most commercial and military standards, many firms are bringing the capability in house, allowing engineers to hook up and auto run the test to meet IEC, Mil-Std, ISO, CE marking and more.

OVERVIEW OF CONDUCTED IMMUNITY TESTS

CONDUCTED IMMUNITY TEST EQUIPMENT

Rent Keysight N9048B CISPR 16 EMI Receiver

Rent Keysight N9048B CISPR 16 EMI Receiver

Rent Keysight N9048B CISPR 16 EMI Receiver

Rent Keysight N9048B CISPR 16 EMI Receiver

Commercial Standards

Military Standards

Common Test Standards

Get Started

The EMC Shop is the largest stocking distributor of conducted susceptibility testing equipment.

Show 12 24 36 48

Conducted Immunity Categories

Electrical Noise/Transient Immunity
Electrical Noise/Transient Immunity
Bulk Current Injection (BCI) Test Equipment
Bulk Current Injection (BCI) Test Equipment
Surge Simulation (Power & Telecom Lines)
Surge Simulation (Power & Telecom Lines)
Voltage Dips and Interruptions Testers
Voltage Dips and Interruptions Testers
Low Frequency Conducted Immunity Testing
Low Frequency Conducted Immunity Testing
Electrostatic Discharge Immunity Test
Electrostatic Discharge Immunity Test

Conducted Immunity Test Equipment, Systems & Solutions

  • Thermo Keytek ECAT w/ E510A Module, 10kv Surge Combination Wave for IEC/EN 61000-4-5

    Thermo Keytek E510A 10kV Surge Generator

    SKU: 10799

    Phase synchronization: ±15° with optional coupler/decoupler
    Pulse current (short circuit): 8/20µs, 0-5.05kA with 2 ohm effective source impedance, ±10%
    Pulse repetition: 1 shot/18 seconds
    Pulse voltage (open circuit): 1.2/50µs, 0-10.1kV ±10% in 1 volt steps
    Repetition time: Adjustable from 300ms to 5s; 1ms resolution
    Typically In Stock
    View Product Cart
  • Thermo Keytek ECAT Transient Generator System

    Thermo Keytek ECAT Transient Generator System

    SKU: 11321

    Pulse current (short circuit): Selectable at 200A max. or 500A max., when the open-circuit voltage is set to 6.0kV.
    Pulse repetition: 1 shot/9 seconds
    Pulse voltage (open circuit): 200V - 6.6kV ± 10%
    Ringwave 0.5 μs/100 kHz: Pulse conforms to IEC/EN 61000-4-12 and ANSI (IEEE) C62.41
    Standards Met: ANSI/IEEE C62.41 Cat. A and B, and various UL standards, including UL 864
    In Stock
    View Product Cart
  • Schloder CWG 1500 Surge Generator, 4.4 kV, 2.2 kA, EN/IEC 61000-4-5

    Schloder CWG 1500 Surge Generator, 4.4 kV, 2.2 kA, EN/IEC 61000-4-5

    SKU: sku-783

    Condition (5-10 Scale): 9
    Warranty: 6 Months
    Calibration: Fresh w/ Data at Time of Order
    Test standard: IEC 61000-4-5
    Accessorries: Complete
    Input: 120VAC/1PH
    Phase synchronization: 0 - 359°, step 1° net sync. triggering
    Polarity: pos / neg / alternate
    Pulse current (short circuit): 0.1 - 2.2 kA
    Pulse voltage (open circuit): 0.2 - 4.4 kV
    Test duration: 10 - 990 sec
    $7,950.00
    1 LEFT
  • CDN-KIT1000 ED3

    EMC Partner CDN-KIT1000 ED3

    SKU: 35425

    Standard: IEC 61000-4-5
    Application: surge on 2 unsymmetrical lines
    Test level surge: max. 6 kV
    EUT voltage per line: max. 200 V DC or 240 V peak
    EUT current per line: max. 4 A cont. or 5 A for 5 min.
    Typically In Stock
    View Product Cart
  • EM Test OCS 500N6F Simulator for Fast/Slow Damped Oscillatory Waves and Ringwave

    EM Test OCS 500N6F Simulator for Fast/Slow Damped Oscillatory Waves and Ringwave

    SKU: 10413

    Burst duration: 50 ms ±20%, at 3 MHz 15 ms ±20%, at 10 MHz 5 ms ±20%, at 30 MHz
    Damping Rate: Peak 5 to be more than 50% of peak 1 value Peak 10 to be less than 50% of peak 1 value
    Oscillation Frequency: 3 MHz, 10 MHz and 30 MHz, ±10%
    Source Impedance: 50 ohm ±20%
    Voltage: Voltage (o.c.) at HV output 450 V - 4,400 V ±10%
    Burst Duration: At least 2s
    Damping Rate-2: Peak 5 to be more than 50% of peak 1 value Peak 10 to be less than 50% of peak 1 value
    Fast Damped Oscillatory Waves: As Per EN/IEC 61000-4-18
    Frequency: 100 kHz ± 10%
    General Data: Technical Details
    Impedance: 12ohm and 30ohm ± 20%
    Oscillation Frequency-2: 100kHz and 1MHz ± 10%
    Peak current: Max. 500A @ 12ohm or Max. 200A @ 30ohm internally;
    Polarity-2: Positive, negative
    Pulse repetition: 1 to 60 transients per minute
    Repetition Rate: Max. 5,000 /s ±10%
    Ringwave 0.5 μs/100 kHz: Pulse conforms to IEC/EN 61000-4-12 and ANSI (IEEE) C62.41
    Source impedance: 200ohm ± 20%
    Spike frequency: 100kHz ± 10%
    Test Voltage: 250 V - 6,000 V ± 10%
    Inquire
    View Product Cart
  • 3ctest SG 5010H 10kV Surge Simulator for IEC 61000-4-5, GB/T, ITU-T K21/K44

    3ctest SG 5010H 10kV Surge Simulator for IEC 61000-4-5, GB/T, ITU-T K21/K44

    SKU: sku-326

    Polarity: +/-, positive first or negative first
    Weight: Approximately 300 kg
    Combination wave pulse 1, 2/50 - 8/20 μs (Hybrid-Surge pulse): Pulse conforms to IEC/EN 61000-4-5
    Coupling: 1 or 3 Phase 16 Amps 250V/450V
    Impedance: 500Ω±10％
    Input voltage UIN: AC220V±10%，50/60H
    Output Current: 10/700 and 5/320±20%μs
    Polarity-2: +/-, positive first or alternate
    Pulse current (short circuit): 150A - 3kA/5kA (±10%)
    Pulse voltage (open circuit): 300V - 6kV/10kV (±10%)
    Standards Met: EN/IEC 61000-4-5, IEC 61643-1, GB/T 17626.5m GB/T 16927.1, ITU-T K21 and ITU-T K44
    Telecom Surge: As per FCC part 68, Pulse B, IEC 61000-4-5, ITU and ETSI recommendations
    Test duration: Voltage - 50μs(±20%); Current - 20μs(±20%)
    Test Voltage: 300V～6Kv/10kV （±10%)
    Transfer Impedance: 15Ω、40Ω（25+15Ω
    View Product Cart
  • 3ctest CWS 600CT Combination Wave & Telecom Surge Simulator, 1.2/50us 8/20us 10/700us 5/320us

    3ctest CWS 600CT Combination Wave & Telecom Surge Simulator, 1.2/50us 8/20us 10/700us 5/320us

    SKU: sku-333

    Polarity: Positive, Negative or Alternate
    Weight: Approx 15 kg (33 lbs)
    Combination wave pulse 1, 2/50 - 8/20 μs (Hybrid-Surge pulse): Pulse conforms to IEC/EN 61000-4-5
    Counter: 1-999
    Coupling: Optional for external SPN series CDN's
    Dimensions: 19 inch/6u
    Frequency Range: 50/60Hz±5%
    Front Time: Voltage: 10us±20%, time to half value: 700us±20%;
    Impedance: 2 phm, Optional 12 ohm and 500 ohm
    Mains & EUT Connections: 4mm banana plug
    Output Current: Front time: 5us±20%, time to half value: 320us±20%
    Polarity-2: Positive, Negative and Alternating
    Pulse current (short circuit): 0.15 kA–3.0kA ±10% （2ohm）
    Pulse Duration: 11s-99s （shortest depends on test voltage）
    Pulse repetition: 1-999
    Pulse voltage (open circuit): 0.3kV–6.0kV ±10%
    RF Connector: BNC, 5VTTL
    Standards Met: UL 1449, ANSI C62.41, IEC 61000-4-5, EN & IEC 60255-5, GB/T 17626.5
    Telecom Surge: As per FCC part 68, Pulse B, IEC 61000-4-5, ITU and ETSI recommendations
    Test duration: 6s-99s
    Test Voltage: 0.2kV–6.0kV,±10%
    Transfer Impedance: 15ohm, 40ohm （automatic switch)
    Voltage Rating: AC 110V/220V , ±10%,
    View Product Cart

Connect with The EMC Shop

Our experienced staff can help you with applications, purchase and rental options.

Contact Form