• Near-Field EMI Scanning

• Quick Detection of RF Emission Sources

• Portable and Lab-Ready Design

• Real-Time RF Visualization

• Simple Setup and Operation

• 30 Hz – 250 kHz Frequency Range

• 2:1 Turns Ratio

• AC/DC Signal Injection

• No Core Saturation

• Up To 60 A Current Capability

• Real-Time 3D Electromagnetic Field Visualization

• Augmented Reality (AR) Measurement Interface

• Wideband and Frequency-Discriminated Measurement

• Compatible with Spectrum Analyzers and RF Probes

• Rapid Identification of Emission Sources

• 63 Amp, 3 Phase, 690 Volt AC Power Handling Capability

• Utilized for conducted emissions measurements and product compliance testing

• Built in accordance to CISPR 16-1-2 requirements.

• CEE / IEC 60309 power connector and socket

• Artificial hand, External 9 kHz high pass filter and separate RF ports to measure each line.

• 50 Ω // 1 µH LISN characterized from 30 Hz – 500 MHz

• V-AMN configuration for measurements on measure asymmetrical (common mode) lines

• 0 to 60 VDC up to 10 Amps continuous power handling

• Built in accordance to ISO 14302, ECSS-E-ST-20-07C Rev 1, SIST EN 16603-20-07:2022 and more

• 4 mm banana sockets connectors

• Wide Frequency Range From 20 Hz To 7 GHz

• EMI Receiver And Spectrum Analyzer Modes

• Low Phase Noise For Accurate Signal Detection

• High Sensitivity For EMI Measurements

• Suitable For Pre-Compliance And Full Compliance Testing

• Programmable AC Output For Precise Voltage And Frequency Control

• Wide Output Voltage Range For Flexible Testing Applications

• Stable And Clean Sine Wave Output

• User-Friendly Front Panel With Digital Display And Control Knob

• Adjustable Frequency Range For Power Simulation Testing

• Vector Network Analysis from 1 Hz to 50 MHz

• Ideal for Control Loop and Stability Testing

• Supports Frequency Response and Impedance Measurement

• Suitable for Power Electronics and EMC Applications

• Compact and Easy to Integrate

• 7.5–18 GHz Frequency Range

• 250W CW Output Power (300W Typical)

• Broadband, High-Gain Amplifier

• Digital Front Panel With System Monitoring

• IEEE-488 (GPIB) Remote Control Interface

• EMC and RF testing antenna

• Suitable for compliance and pre-compliance testing

• Stable and repeatable measurements

• Easy integration with test setups

• Ideal for lab environments

• AC/DC Current Measurement Capability

• Non-Intrusive Clamp-On Design

• Designed for Oscilloscope Compatibility

• Accurate Current Waveform Analysis

• Ideal for Power and Signal Troubleshooting

• 25 MHz – 1 GHz Broadband Frequency Coverage

• Tuned Dipole Elements for Accurate EMC Measurements

• Complete Kit with Mounting Hardware and Accessories

• Non-Invasive Radiated Emissions and Immunity Testing

• Compatible with Signal Generators and Measurement Receivers