EMC Test Equipment

EMC Test Equipment Test Equipment, Systems & Solutions

• 

  3ctest CST 1075D Pulsed Sinusoidal Disturbances Generator

  SKU: 11412

  Frequency Range: 1 μHz-35 MHz

  Standards Met: ISO 7637-4

  Applications: Automotive EV EMC

  Input Interface: N (female)

  Frequency Resolution: 1 μHz

  Internal Modulation: AM, FM, Phase, Sinusoidal wave, Rectangular wave, triangular wave/sawtooth wave

  Typically In Stock

  VIEW PRODUCT Cart

• 

  3ctest RSG Ripple Generator for EV EMC Testing

  SKU: 10113

  Test Standards: ISO 7637-4, ISO 21498-2 and VW 80300

  Requires: TPT-7637-4C100B

  Applications: EV EMC testing on HV Lines

  Frequency Range: 10 Hz - 300 kHz

  Frequency step: 0.01 Hz

  Open circuit output voltage: 80 Vp-p Max

  Ripple Dwell Time: 2s - 999 s, resolution 0.1 s

  Primary Current Coupling: 32 Amps

  Secondary Current Coupling: 100 Amps

  Umax: 2.5 Volts to 25 Volts

  In Stock

  VIEW PRODUCT Cart

• 

  RFCP400M10k Current Probe

  SKU: 8189

  Frequency Range: 10 kHz to 400 MHz

  Maximum RMS: Current 4 A

  Test Standards: MIL-STD CS114, CS115, CS116

  Hole Diameter: 2.0 inches [50.8 mm]

  Weight: 2.2 lbs [1.0 kg]

  Nominal Transfer Impedance: -6 dBΩ

  Maximum Peak Current: 15 A

  Cost New:

  Was:

  Price Now:

  $295.00 - $4,750.00

  Typically In Stock

  ORDERING OPTIONS

• 

  The EMC Shop SS400M-75 RF Power Amplifier, 10 kHz - 400 MHz

  SKU: 12298

  Max Frequency: 400 MHz

  Min Frequency: 9 kHz

  Output Power: 75 Watts

  Applications: RF Conducted Immunity, Military and Aerospace EMC Testing

  Standards: ISO 11452-4, DO-160 Section 20, MIL-STD-461 CS 114

  Gain: 48 dB

  AC Input Power: 100-220V/1PH

  Cooling: Forced Air

  Cost New:

  Was:

  Price Now:

  $975.00 - $14,750.00

  IN STOCK

  ORDERING OPTIONS

• 

  ECO2G 2 GHz EMC Calibration Oscilloscope ESD Gun Verification

  SKU: 5501

  Sample Rate: 5 GSa/s (10 GSa/s ESR) ADC per analog channel

  Record Length: up to 500 Mpts

  Waveform Capture Rate: Up to 750,000 wfm/s (Sequence mode)

  Pre-Programmed Settings: IEC 61000-4-2 150pF/330 Ohm, All four R/C Combinations of ISO 10605

  Vertical Scales: 0.5 mV/div to 10 V/div

  Interfaces: USB Hosts, USB Device (USBTMC), LAN（VXI-11/Telnet/Socket, micro SD card, Pass/Fail, Trigger Out, HDMI

  Protocol Capabilities: Serial bus triggering and decoder - I2C, SPI, UART, CAN, LIN, CAN FD, FlexRay, I2S, MIL-STD-1553B, SENT, and Manchester

  Applications: How to Capture an Electrical Transient Using an Oscilloscope, EMC Precompliance Testing

  Cost New:

  Was:

  Price Now:

  $395.00 - $10,950.00

  IN STOCK

  ORDERING OPTIONS

• 

  Amplifier Research FL8018 Isotropic Field Probe, CW and Pulse, 18 GHz

  SKU: 11018

  Frequency Range: 20 MHz - 18 GHz

  Measurement Type: CW, AM & Pulse

  Field Strength Range: 2 – 1000 V/m

  Dynamic Range: >54 dB

  Isotropic Deviation (Measured at Ortho Angle): ±0.5 dB @ 100 MHz

  Applications: Automotive EMC, Commercial EMC, Aviation EMC, Military EMC, Wireless R&D

  Standards Met: MIL-STD 461 RS103, DO-160

  Additional Standards Met: IEC 61000-4-3

  Inquire for Availability

  VIEW PRODUCT Cart

• 

  Rent Keysight N9048B CISPR 16 EMI Receiver

  SKU: 22153

  Frequency Range: 1 Hz to 26.5 GHz

  Standards Met: CISPR 16-1-1, ANSI C63.2, FCC

  Calibration: Accredited ISO 17025

  Options: See "Installed Options"

  Applications: Conducted Emissions, Radiated Emissions,

  Technical Note: Differences Between EMI Test Receivers and Spectrum Analyzers

  IN STOCK

  VIEW PRODUCT Cart

• 

  MIL-STD-461 CS101 Test Equipment Setup Rental Package

  SKU: 22047

  Test Standards: MIL-STD-461 CS101

  Applications: Conducted immunity and susceptibility, EMC precertification testing

  Frequency Range: 30 Hz to 150 kHz (Extendable down to 2 Hz and up to 500 kHz)

  Test Setup: Quick Start Guide Provided

  Shipping: Same Day, Larger Systems go Freight

  Cost New:

  Was:

  Price Now:

  $975.00 - $1,975.00

  Usually ships in 24 hours.

  ORDERING OPTIONS

• 

  3ctest Turnkey Automotive EMI Test System

  SKU: 11932

  Applications: EMC Testing on EV Electric Vehicles Batteries & Charging Stations, Automotive Electrical Disturbances

  ISO Automotive Standards: ISO 7637-2, ISO 16750-2, ISO 11452-8

  Max Voltage (w/ Built In CDN): 60 Volts

  Max Current (w/ Built In CDN): up to 200 Amps

  SAE Automotive Standards: SAE J1113, SAE J1455

  Typically In Stock

  VIEW PRODUCT Cart

• 

  Lumiloop LSProbe 1.2 Laser Powered Field Probe for CW and Pulse Testing

  SKU: 7384

  Application/Test Type: Radiated Immunity

  Field Strength Range: 0.1 V/m to 1,000 V/m (7 to 10 kV/m under 30 MHz)

  Frequency Range: 10 Hz to 8.2 GHz

  Resolution: <0.01 V/m

  Test Standards: MIL-461 RS103, IEC/EN 61000-4-3, ISO 11452-2, DO-160 Section 20

  Typically In Stock

  VIEW PRODUCT Cart

• 

  DP7 High Voltage Probe for Surge Generator Waveform Verification

  SKU: 6533

  Bandwidth: DC - 70 MHz

  Attenuation: 1:100 and 1:1000

  Accuracy: ±2%

  Input Voltage Range: < +700V for X100, < +7000V for X1000

  Output Voltage: ≤ + 7000V

  Output Impedance: 50 Ω

  Standard Met: IEC 61000-4-5, IEC 61010-031 Category I

  Applications: Conducted Emissions, High Voltage Floating Measurements, Voltage Surge Measurement, Power Electronics System Design, Electronic Ballast Design

  Cost New:

  Was:

  Price Now:

  $185.00 - $1,850.00

  IN STOCK

  ORDERING OPTIONS

• 

  ETS-Lindgren 3116C Double-Ridged Waveguide Horn, 10 - 40 GHz

  SKU: 3677

  Frequency Range: 10 GHz - 40 GHz

  Applications: Antenna Pattern Measurements, Emissions

  Test Standards: IEC 61000-4-3, ANSI C63.4

  Pattern Type: Directional

  Maximum Continuous Power: 40 W (10 GHz) to 20 W (40 GHz)

  Connectors: Type K (F) (2.92 mm)

  VSWR: 2.5:1 Maximum

  Typically in Stock

  VIEW PRODUCT Cart