EMC/EMI Test & Measurement Equipment - The EMC Shop - Page 4

Home
EMC Test Equipment

Show 12 24 36 48 96

EMC Test Equipment Categories

Transient Generators

Transient Generators

EMI Receivers/EMC Analyzers

EMI Receivers/EMC Analyzers

RF Power Amplifiers

RF Power Amplifiers

Electric Field Strength Measurement

Electric Field Strength Measurement

RF Conducted Immunity Test Systems

RF Conducted Immunity Test Systems

Line Impedance Stabilization Networks (LISN's)

Line Impedance Stabilization Networks (LISN's)

EM Coupling Clamps

EM Coupling Clamps

Coupling Decoupling Networks (CDN's)

Coupling Decoupling Networks (CDN's)

RF Current Probes/Monitors

RF Current Probes/Monitors

EMC/EMI Signal Generators

EMC/EMI Signal Generators

Calibration Equipment

Calibration Equipment

Software for EMC Testing

Software for EMC Testing

EMC Test Equipment Test Equipment, Systems & Solutions

3cTest SEPN 38100T Surge/EFT 3 Phase Coupling Network

SKU: 7271

EUT Load Capacity (AC): 380V, 100 A, 50 Hz/60 Hz three-phase-five-wire

EUT Load Capacity (DC): 450 V, 100 A

Fuse: 6 A

Max Power Consumption: 200 W

Dimensions: 600 x 800 x 1830 mm (W x D x H) 23.6 x 31.5 x 72 in

Weight: 288 kg / 635 lbs

Standards Met: IEC 61000-4-4, IEC 61000-4-5

Applications: Conducted Immunity

In Stock

VIEW PRODUCT Cart
Langer EMV XF1 Near-Field Probes 30 MHz to 6 GHz

SKU: LAN-XF1

Frequency Range: 30 MHz - 6 GHz

Connectors: SMA (m)

Applications: E-Field, H-Field

Resolution: < 1 mm

Cost New:

Was:

Price Now:

$239.00 - $2,639.00

IN STOCK

ORDERING OPTIONS
3ctest CST 1075D Pulsed Sinusoidal Disturbances Generator

SKU: 11412

Frequency Range: 1 μHz-35 MHz

Standards Met: ISO 7637-4

Applications: Automotive EV EMC

Input Interface: N (female)

Frequency Resolution: 1 μHz

Internal Modulation: AM, FM, Phase, Sinusoidal wave, Rectangular wave, triangular wave/sawtooth wave

Typically In Stock

VIEW PRODUCT Cart
3ctest RSG Ripple Generator for EV EMC Testing

SKU: 10113

Test Standards: ISO 7637-4, ISO 21498-2 and VW 80300

Requires: TPT-7637-4C100B

Applications: EV EMC testing on HV Lines

Frequency Range: 10 Hz - 300 kHz

Frequency step: 0.01 Hz

Open circuit output voltage: 80 Vp-p Max

Ripple Dwell Time: 2s - 999 s, resolution 0.1 s

Primary Current Coupling: 32 Amps

Secondary Current Coupling: 100 Amps

Umax: 2.5 Volts to 25 Volts

In Stock

VIEW PRODUCT Cart
RFCP400M10k Current Probe

SKU: 8189

Frequency Range: 10 kHz to 400 MHz

Maximum RMS: Current 4 A

Test Standards: MIL-STD CS114, CS115, CS116

Hole Diameter: 2.0 inches [50.8 mm]

Weight: 2.2 lbs [1.0 kg]

Nominal Transfer Impedance: -6 dBΩ

Maximum Peak Current: 15 A

Cost New:

Was:

Price Now:

$295.00 - $4,750.00

Typically In Stock

ORDERING OPTIONS
The EMC Shop SS400M-75 RF Power Amplifier, 10 kHz - 400 MHz

SKU: 12298

Max Frequency: 400 MHz

Min Frequency: 9 kHz

Output Power: 75 Watts

Applications: RF Conducted Immunity, Military and Aerospace EMC Testing

Standards: ISO 11452-4, DO-160 Section 20, MIL-STD-461 CS 114

Gain: 48 dB

AC Input Power: 100-220V/1PH

Cooling: Forced Air

Cost New:

Was:

Price Now:

$975.00 - $14,750.00

IN STOCK

ORDERING OPTIONS
ECO2G 2 GHz EMC Calibration Oscilloscope ESD Gun Verification

SKU: 5501

Sample Rate: 5 GSa/s (10 GSa/s ESR) ADC per analog channel

Record Length: up to 500 Mpts

Waveform Capture Rate: Up to 750,000 wfm/s (Sequence mode)

Pre-Programmed Settings: IEC 61000-4-2 150pF/330 Ohm, All four R/C Combinations of ISO 10605

Vertical Scales: 0.5 mV/div to 10 V/div

Interfaces: USB Hosts, USB Device (USBTMC), LAN（VXI-11/Telnet/Socket, micro SD card, Pass/Fail, Trigger Out, HDMI

Protocol Capabilities: Serial bus triggering and decoder - I2C, SPI, UART, CAN, LIN, CAN FD, FlexRay, I2S, MIL-STD-1553B, SENT, and Manchester

Applications: How to Capture an Electrical Transient Using an Oscilloscope, EMC Precompliance Testing

Cost New:

Was:

Price Now:

$395.00 - $10,950.00

IN STOCK

ORDERING OPTIONS
Amplifier Research FL8018 Isotropic Field Probe, CW and Pulse, 18 GHz

SKU: 11018

Frequency Range: 20 MHz - 18 GHz

Measurement Type: CW, AM & Pulse

Field Strength Range: 2 – 1000 V/m

Dynamic Range: >54 dB

Isotropic Deviation (Measured at Ortho Angle): ±0.5 dB @ 100 MHz

Applications: Automotive EMC, Commercial EMC, Aviation EMC, Military EMC, Wireless R&D

Standards Met: MIL-STD 461 RS103, DO-160

Additional Standards Met: IEC 61000-4-3

Inquire for Availability

VIEW PRODUCT Cart
Rent Keysight N9048B CISPR 16 EMI Receiver

SKU: 22153

Frequency Range: 1 Hz to 26.5 GHz

Standards Met: CISPR 16-1-1, ANSI C63.2, FCC

Calibration: Accredited ISO 17025

Options: See "Installed Options"

Applications: Conducted Emissions, Radiated Emissions,

Technical Note: Differences Between EMI Test Receivers and Spectrum Analyzers

IN STOCK

VIEW PRODUCT Cart
MIL-STD-461 CS101 Test Equipment Setup Rental Package

SKU: 22047

Test Standards: MIL-STD-461 CS101

Applications: Conducted immunity and susceptibility, EMC precertification testing

Frequency Range: 30 Hz to 150 kHz (Extendable down to 2 Hz and up to 500 kHz)

Test Setup: Quick Start Guide Provided

Shipping: Same Day, Larger Systems go Freight

Cost New:

Was:

Price Now:

$975.00 - $1,975.00

Usually ships in 24 hours.

ORDERING OPTIONS
3ctest Turnkey Automotive EMI Test System

SKU: 11932

Applications: EMC Testing on EV Electric Vehicles Batteries & Charging Stations, Automotive Electrical Disturbances

ISO Automotive Standards: ISO 7637-2, ISO 16750-2, ISO 11452-8

Max Voltage (w/ Built In CDN): 60 Volts

Max Current (w/ Built In CDN): up to 200 Amps

SAE Automotive Standards: SAE J1113, SAE J1455

Typically In Stock

VIEW PRODUCT Cart
Lumiloop LSProbe 1.2 Laser Powered Field Probe for CW and Pulse Testing

SKU: 7384

Application/Test Type: Radiated Immunity

Field Strength Range: 0.1 V/m to 1,000 V/m (7 to 10 kV/m under 30 MHz)

Frequency Range: 10 Hz to 8.2 GHz

Resolution: <0.01 V/m

Test Standards: MIL-461 RS103, IEC/EN 61000-4-3, ISO 11452-2, DO-160 Section 20

Typically In Stock

VIEW PRODUCT Cart

Previous
1
2
3
4
5
6
7
8
9
Next