EMC Test Equipment

EMC Test Equipment Test Equipment, Systems & Solutions

• 

  Solar 9354-1 Transient Generator for MIL-STD-461 CS116

  SKU: 10507

  Applications: RF Current Monitoring, EMC BCI Tests

  Test Standards: MIL-STD-461 CS116

  Industry: Military EMC Testing

  Typically In Stock

  VIEW PRODUCT Cart

• 

  Com-Power CGO-505 Comb Generator 5 MHz - 1 GHz in 5 MHz step

  SKU: 0659

  AC Power Adapter: 6 VDC, 500 mA / 110VAC 60 Hz or 230 VAC 50 Hz

  Antennas: 5 and 12 inch Monopole

  Application/Test Type: EMI Radiated Site Reference Source

  Battery: 6V NiMH, 1 Ah

  Dimensions: 7 x 0.75 inches / 17.7 x 1.9 cm

  Frequency Range: 5 MHz to 1 GHz in 5 MHz steps

  Operation Time: 18 Hours Typical With Fully Charged Battery

  Polarity: Vertical and Horizontal

  Cost New:

  Was:

  Price Now:

  $395.00 - $3,275.00

  Typically in Stock

  ORDERING OPTIONS

• 

  ETS-Lindgren 7405 E & H Near Field Probe Set

  SKU: sku-396

  Weight: 2 lbs (0.91 kg)

  Current Rating: 800 mA (per line), 1.6 Amps (per pair)

  Dimensions: 10.8” x 4.5” x 3.8” (275 mm x 115 mm x 96 mm)

  Frequency Range: 150 kHz to 3 GHz

  Isolation: 150 kHz to 1.5 MHz: 35 dB to 55 dB (increasing linearly with the log of freq.) 1.5 MHz to 30 MHz: 55 dB

  Mains & EUT Connections: D-sub 25 pin female connectors

  RF Connector: 50Ω N-type (female)

  Standards Met: EN 55022 (CISPR 22), CISPR 16-1-2

  Voltage Rating: 50 VDC / 32 VAC (line to ground @ 50/60 Hz)

  VIEW PRODUCT Cart

• 

  Schaffner NSG 2025-4 EFT / Burst Generator Built in Three Phase Coupler

  SKU: 11294

  Burst (EFT) 5/50 ns: Pulse conforms to IEC/EN 61000-4-4

  Burst frequency: 0.1 kHz - 1,000 kHz

  Burst time: Rise Time: 5ns ±20% (50 W, 10 - 90%) Pulse Width: 50ns ±30% (50 W and 1 W), 100ns ±50% open circuit

  Coupling: Line to reference ground (IEC 1000-4-4), selected lines together to reference ground, all lines to reference ground (common mode)

  Mains & EUT Connections: HV Coax (Direct); L, N and PE via Coupler

  Phase synchronization: Asynchronous/synchronous 0 - 360° ±2°

  Polarity: Positive/Negative

  Pulse amplitude: 200 Volts - 4.5 kV (20 Volt Steps)

  Repetition time: 100ms to 10s

  Test duration: 1 to 150 pulses (15ms burst duration as per IEC 61000-4-4 up to 10 kHz)

  Cost New:

  Was:

  Price Now:

  $975.00 - $6,750.00

  In Stock

  ORDERING OPTIONS

• 

  Solar 8616-5-TS-200-N 5uH EMI LISN

  SKU: SOLA-8616-5-TS-200-N

  Test Standards: MIL-STD-462, DO-160, FCC Part 18

  Applications: Military EMC Testing, Conducted Emissions Testing

  Max Current: 100 Amps

  Frequency Range: 10 kHz – 30 MHz

  Coupling Capacitor: 0.25 µF

  RF Connector: N-Type(f)

  Inductance: 5 µH

  Videos: Debugging Failures

  Typically In Stock

  VIEW PRODUCT Cart

• 

  Schwarzbeck TEMP 8400 Tempest AMN (LISN)

  SKU: 6991

  Frequency Range: 9 kHz - 1 GHz

  Max. cont. current: 16 A, 25 A (Limited time, 15 mins)

  Max Voltage (DC to 400 Hz): 250 V AC

  Insertion loss (EUT – AE): Typ. 25 - 60 dB

  Applications: Conducted Emissions, BCI Testing , Automotive EV EMC

  Cost New:

  Was:

  Price Now:

  $7,945.00

  Typically In Stock

• 

  EMC Partner IMU-MGS Transient Generator

  SKU: 11129

  Conducted Immunity Setup and Testing: Surge Immunity (Combo/Ring/Telecom Waves), EFT/Burst

  Test Standards: IEC/EN 61000-4-4, IEC/EN 61000-4-5, IEC/EN 61000-4-11

  Output Levels: up to 5kV

  Cost New:

  Was:

  Price Now:

  $1,195.00 - $2,295.00

  Typically In Stock

  ORDERING OPTIONS

• 

  Haefely PIM 100 Combination Wave Impulse Module

  SKU: 10297

  Output: Combination wave pulse 1, 2/50 - 8/20 μs (Hybrid-Surge pulse) up to 7.8kV

  Coupling (Max EUT Power): 3 Phase - 100 Amps, 690 VAC

  Test Standards: IEC/EN 61000-4-5 Ed. 1 & 2, ANSI C62.45

  Applications: Surge immunity - Combo Wave, Ring Wave and Oscillatory Waves, EMC Precompliance Testing

  Pulse current (short circuit): 0.1 – 3.7 kA ±10% (8 us ±20% risetime)

  Pulse repetition: 10 seconds / 6 per minute

  Features: Impulse voltage and current monitors

  In Stock

  VIEW PRODUCT Cart

• 

  Teseq NNB 51 Line Impedance Stabilization Network Dual-Line-V-LISN

  SKU: 10154

  Weight: 12 kg (26.5 pounds)

  Application/Test Type: Measure distortion signals on power mains, EMC Precompliance, Conducted Emissions

  Current Rating: 16 Amps Max

  Frequency Range: 9 kHz to 30 MHz

  RF Connector: N female

  RF Input Voltage: 250 Volts max

  Standards Met: CISPR 16-1-2, MIL-STD-461, FCC Part 15, ANSI C63.4

  RENTAL ONLY

  VIEW PRODUCT

• 

  Com-Power LI-550A Line Impedance Stabilization Network (LISN)

  SKU: 10114

  Weight: 14 lbs. / 6.3 kg

  Application/Test Type: Power line conducted emissions tests

  Current Rating: 50 Amps (AC), 35 Amps (DC)

  Dimensions: 13 x 7 x 7 inches / 33 x 17.7 x 17.7 cm

  Frequency Range: 100 kHz to 108 MHz

  Inductors: 5 µH (air-core)

  Insertion Loss: 1.5 dB (150 kHz to 30 MHz)

  Isolation: 20 - 40 dB (100 kHz to 3 MHz) 40 dB ( 3 MHz to 30 MHz)

  Mains & EUT Connections: Superior Electric SUPERCON® shrouded sockets

  RF Connector: 50Ω N-type (female)

  Standards Met: CISPR 25 / CISPR 16-1-2

  Voltage Rating: 270 VAC (Line to Ground), 380 VDC

  Cost New:

  Was:

  Price Now:

  $175.00 - $1,975.00

  1 Set

  ORDERING OPTIONS

• 

  Noiseken INS-4040 Impulse Noise Simulator

  SKU: 8882

  Test Standards: IEC 61000-4-4, MIL-STD-461 CS115

  Applications: EFT/Burst, EMC Precompliance, BCI Testing

  Pulse Widths: 10ns, 50ns, 100ns, 200ns, 400ns, 500ns, 800ns and 1000ns

  Output Voltage: 0.01~2.00kV ±10% with 50Ω Load

  EUT Power Handling: AC240V Single phase, DC60V, 16A

  Typically In Stock

  VIEW PRODUCT Cart

• 

  EMC PARTNER IMU-MGE EFT/BURST, SURGE, RINGWAVE AND 10/700US IMPULSE GENERATOR

  SKU: 11126

  Test Standards: IEC/EN 61000-4-4, IEC/EN 61000-4-5, IEC/EN 61000-4-11

  Setup Information: Surge Immunity (Combo/Ring/Telecom Waves), EFT/Burst

  Impulse Levels: up to 8 kV

  Inquire for Lead Time

  VIEW PRODUCT Cart