LNA18G Low Noise Wideband Preamplifier 1 - 18 GHz - The EMC Shop

LNA18G Low Noise Wideband Preamplifier 1 - 18 GHz

Condition:
New
Nominal Frequency Range:
1 - 18 GHz
Useable Frequency Range:
0.5 - 20 GHz
Connectors:
50 Ω N/SMA
Noise Figure:
2 dB
Gain:
Typ. 30 dB +/- 5 dB
Max. Input Power:
-10 dBm (97 dBµV)
SWR typ.:
<2
Manufacturer:
The EMC Shop
Online Orders Ship Same Day

 

Downloads

Datasheet (PDF File)

$450.00

 

SKU:
7125-RE
Availability:

In Stock

Getting Started...

Overview

The EMC Shop LNA18G Low Noise Low Power Wideband Amplifier is for increasing sensitivity at field strength measurements and for general attenuation measurements up to 18 GHz. Due to the built-in rechargeable battery, operation without power supply is possible for approx. 8 hours.

The amplifier Input comes with an SMA female connector. A coaxial microwave cable of 0.5 m length is supplied to connect the Antenna with the Amplifier. The cable is equipped with N-male and SMA male connectors.

Usually, the amplifier should be installed very close to the antenna. The Amplifier Housing is equipped with rubber pads for placement on horizontal surfaces. Further, there are 22 mm holes in the housing to accept the mounting tube of The EMC Shop. The antenna mounting tube is usually oriented horizontally with the N-female output of the amplifier facing to ground. This avoids undesired bending of the coaxial cable.

Videos

Key Considerations

Manufacturer:
The EMC Shop
Nominal Frequency Range:
1 - 18 GHz
Useable Frequency Range:
0.5 - 20 GHz
Connectors:
50 Ω N/SMA
Noise Figure:
2 dB
Gain:
Typ. 30 dB +/- 5 dB
Max. Input Power:
-10 dBm (97 dBµV)
SWR typ.:

Related EMC Equipment & Solutions

Teseq LNA 6018 Low Noise Amplifier 1 GHz to 18 GHz

Teseq LNA 6018 Low Noise Amplifier 1 GHz to 18 GHz

SKU: sku-83

Weight: 220 grams (0.3 Lbs)
Application/Test Type: Significantly increase the sensitivity of virtually all spectrum analyzers and other RF measuring instruments
Connector: IN: SMA female 50 Ohms; OUT: SMA male 50 Ohms
Dimensions: 39 mm x 88 mm x 36 mm
Frequency Range: 1 GHz - 18 GHz
Gain: 22 dB typical (± 3 dB flatness)
Input: less than -10 dBm
VSWR: less than 2:1 typical
View Product Cart
Com-Power PAM-840A Ultra Wideband Preamplifier, 18 GHz- 40 GHz, 37 dB Gain

Com-Power PAM-840A Ultra Wideband Preamplifier, 18 GHz- 40 GHz, 37 dB Gain

SKU: 10214

Weight: 2.5 lbs (1.1 3Kg)
Application/Test Type: Increases system sensitivity enhancing the capability of measurement system to measure low level signals. It also provides input isolation to your spectrum analyzer or receiver.
Connector: 50Ω 2.9mm female
Dimensions: 7.6 x 5.95 x 2.17 inches (192 x 151 x 55 mm)
Frequency Range: 18 GHz - 40 GHz
Gain: 42 dB typical (± 2 dB flatness)
Input: +15Vdc, 500 mA
Maximum Continuous Power: +10 dBm @ 1 dB compression
VSWR: 2.25:1 maximum
Inquire for Availability
View Product Cart
PA26G K Band Preamplifier 18 GHz - 26.5 GHz - The EMC Shop

PA26G K Band Preamplifier 18 GHz - 26.5 GHz

SKU: 8298

Frequency Range: 18 GHz - 26.5 GHz
Gain: 30 dB
Noise Figure: 6.0 dB
RF Input Damage Level: +20 dBm
Input/Output Return Loss: 10 dB
Power Supply (AC Adapter Provided): 100 VAC min to 240 VAC max
Input/Output Connector Type: 2.92 mm (F)
AC to DC power converter: 2.5 mm DC Jack (power converter included)
In Stock
View Product Cart
Teseq LNA 6901 Low Noise Amplifier 9 kHz to 1 GHz

Teseq LNA 6901 Low Noise Amplifier 9 kHz to 1 GHz

SKU: sku-82

Weight: .27 Lb's (127 grams)
Application/Test Type: Increase the sensitivity of virtually all spectrum analyzers and other RF measuring instruments
Connector: N-type 50 Ohms
Dimensions: 28 mm x 95 mm x 27 mm
Frequency Range: 9 kHz to 1 GHz (nominal range); 9 kHz to 2 GHz (utilizable range)
Gain: 28 dB typical (±1 dB flatness)
Input: -20 dBm (87 dBμV)
Maximum Continuous Power: +8 dBm @ 1 dB compression
VSWR: Less Than 1.5:1
View Product Cart

Connect with The EMC Shop

Our experienced staff can help you with applications, purchase and rental options.

Contact Form