Overview
The CGR 5.4 Cable measuring guide rail, with the exception of the drive unit, is fabricated from plastic (PVC and reinforced fibreglass). Metal parts are located only in the base plate and the drive mechanism (max. 0.3 m above ground level).
The Cable Guide Rail is used for the remotely-controlled positioning of an absorbing clamp along an electric cable. Automatic measurement of the RFI power according to CISPR, EN, ANSI, VCCI and VDE standards are possible.
The IEEE 488.2 (GPIB) bus provides an additional control option for all functions, when operated with the SCU/MCU or NCD Controller.
| Technical Data | |
| Moving range | 5.4 m (without clamp) |
| Total measurement length | 6.0 m (with clamp) |
| Overall length | 6.2 m |
| Track height | 0.8 m above floor |
| Permissible load | 15 kg |
| Material | Plastic + reinforced fibreglass |
| Cross-section | 100 mm x 100 mm |
| Base L x W | 0.3 m x 0.3 m (with supporting pillars) |
| Positioning speed adjustable between | 5.0 – 30.0 cm/s |
| Positioning accuracy | better +/- 1 cm |
| Motor | Brushless DC motor 200 W |
| Interference suppression | 20 dB under limits EN 55022 class B |
| Current consumption | max. 2A |
| Voltage | 208-230 VAC, 50/60 Hz, single phase |
| Discharge current | 25mA per drive unit (higher in the moment when powering on) |
| Control cable | Fibre optic lines |
| Remote control via | IEEE interface |
| Antenna support drive | Toothed belt |
| Material of toothed belts | Kevlar reinforced (non-metallic) |
| Temperature range | +10 °C...+35 °C |
| Total weight | approx. 70 kg |
| Accessories | Interface for SCU/MCU/NCD Controller 3 m power supply cable Service manual |
