Overview
The Teseq LNA 6900 is a low noise amplifier with 25 dB of gain covering the nominal frequency range 9 kHz to 2 GHz and can be used up to 4 GHz. With its high gain and low noise figure, it will significantly increase the sensitivity of virtually all spectrum analyzers and other RF measuring instruments. All measuring instruments have a ‘noise figure’, which is a measure of how good the instrument is at measuring low level signals, the lower this figure, the better, although the lowest signal level will still be governed by the measurement bandwidth. A typical spectrum analyzer may have a noise figure of 20 dB or more, whereas a typical receiver may have a noise figure of 10 dB. The preamplifier has a noise figure of typically 4 dB, significantly enhancing the low level performance of such instruments, enabling signals that were previously masked by noise to be seen.
The low noise amplifier can be connected directly to the RF input (N) of the spectrum analyzer or EMI-receiver. If the LNA 6900 is used with the Teseq receiver SCR 35xx / SMR 45xx, the power supply is provided directly by the receiver via the cable LE 237. Alternatively the power supply unit PSU 6000 can be used.
Features & Specifications of Teseq LNA 6900:
- Frequency range: 9 kHz to 2 GHz (nominal range); 9 kHz to 4 GHz (utilizable range)
- Gain: typ. 25 dB
- Gain flatness: +0.5 / -3 dB
- RF-Input: N - female, 50 Ω
- RF-Output: N - male, 50 Ω
- VSWR (input): typ. 1.5 (above 20 kHz)
- Noise figure: typ. 4 dB
- 1 dB-compression (output): >+12.5 dBm (119.5 dBμV)
- Intercept point IP3 (output): typ. +33 dBm
- Max. input (linear): -12.5 dBm (94.5 dBμV)
- DC-power supply: 11 to 15 V
- DC-current: approx. 112 mA
- DC-connector: ODU-female, plus on inner conductors
- Operating temperature range: 0° to 40°C
- Storage temperature range: -20° to 60°C
- Size (W x D x H) (without connectors): 27 mm x 50 mm x 27 mm
- Size (W x D x H) (including connectors): 28 mm x 95 mm x 27 mm
- Weight: approx. 127 g
