• 150 kHz – 80 MHz Operating Range

• 250 A High Current Capability

• Controlled RF Signal Injection

• Stable Power Line Isolation

• ISO 7637 Conducted Immunity Compliant

• Measures differential and common mode currents

• Wide frequency range: 10 kHz to 500 MHz

• Ideal for EMC testing and conducted emissions analysis

• Clamp-on design for easy setup and positioning

• Suitable for laboratory testing and troubleshooting

• Measures common mode currents

• Wide frequency range: 10 kHz to 1 GHz

• Ideal for EMC testing and conducted emissions analysis

• Clamp-on design for easy installation and positioning

• Suitable for laboratory testing and EMI troubleshooting

• Compact design with approximately 71 mm outer diameter

• 32 mm internal diameter for easy cable clamping

• Suitable for both laboratory and field testing

• Enables measurement of common mode and differential currents

• Ideal for EMC testing and troubleshooting applications

• Complete solution for current monitoring and calibration

• Wide frequency range coverage (10 kHz to 1 GHz)

• High-precision measurement of differential and common mode currents

• Seamless compatibility between probes and calibration fixtures

• User-friendly design with quick setup and secure locking mechanisms

• Near-Field EMI Scanning

• Quick Detection of RF Emission Sources

• Portable and Lab-Ready Design

• Real-Time RF Visualization

• Simple Setup and Operation

• 30 Hz – 250 kHz Frequency Range

• 2:1 Turns Ratio

• AC/DC Signal Injection

• No Core Saturation

• Up To 60 A Current Capability

• Real-Time 3D Electromagnetic Field Visualization

• Augmented Reality (AR) Measurement Interface

• Wideband and Frequency-Discriminated Measurement

• Compatible with Spectrum Analyzers and RF Probes

• Rapid Identification of Emission Sources

• 63 Amp, 3 Phase, 690 Volt AC Power Handling Capability

• Utilized for conducted emissions measurements and product compliance testing

• Built in accordance to CISPR 16-1-2 requirements.

• CEE / IEC 60309 power connector and socket

• Artificial hand, External 9 kHz high pass filter and separate RF ports to measure each line.

• 50 Ω // 1 µH LISN characterized from 30 Hz – 500 MHz

• V-AMN configuration for measurements on measure asymmetrical (common mode) lines

• 0 to 60 VDC up to 10 Amps continuous power handling

• Built in accordance to ISO 14302, ECSS-E-ST-20-07C Rev 1, SIST EN 16603-20-07:2022 and more

• 4 mm banana sockets connectors

• Wide Frequency Range From 20 Hz To 7 GHz

• EMI Receiver And Spectrum Analyzer Modes

• Low Phase Noise For Accurate Signal Detection

• High Sensitivity For EMI Measurements

• Suitable For Pre-Compliance And Full Compliance Testing

• Programmable AC Output For Precise Voltage And Frequency Control

• Wide Output Voltage Range For Flexible Testing Applications

• Stable And Clean Sine Wave Output

• User-Friendly Front Panel With Digital Display And Control Knob

• Adjustable Frequency Range For Power Simulation Testing