Overview
The extension kit for the CAS ISN is made to perform transmission and crosstalk measurements on
impedance stabilization network (ISN) for unshielded balanced pairs. In combination with the CAS ISN
and its extensions for T2 and cable category 6 all necessary adapter have been included to measure
common mode (CM) impedance, phase angle, voltage division factor, decoupling attenuation (isolation),
longitudinal conversion loss (LCL), transmission and crosstalk measurements.
Features & Specifications of Teseq CAS ISN Extension:
- Frequency range: (100 kHz) 1 MHz to 300 MHz
- Impedance ratio (unbalanced : balanced): 50 : 100
- Insertion loss, typical: 16.2 dB at 30 MHz (back to back; 8.1 dB for single unit)
- Flatness, typical: < 1 dB at 100 kHz to 300 MHz
- VSWR, typical
- 50 Ω port: < 1:1.25 at 1 MHz to 300 MHz (100 kHz < 1:1.5)
- 100 Ω port: < 1:1.25 at 100 kHz to 300 MHz
- LCL, typical, 100 Ω port:
- 90 dB at 100 kHz
- 80 dB at 10 MHz
- 55 dB at 100 MHz
- CMR, typical: 65 dB to 25 dB at 1 MHz to 300 MHz
- Amplitude balance, typical:
- < 0.1 dB at 100 kHz to 100 MHz
- < 0.2 dB at 100 MHz to 300 MHz
- Phase balance, typical:
- < 2° at 100 kHz to 100 MHz
- < 5° at 100 MHz to 300 MHz
- Max. power: 20 dBm
- Connector
- 50 Ω port: BNC female
- 100 Ω port: 1 mm female (2x 100 Ω port, 1x ground)
- Dimension (LxWxH): 72 mm x 32 mm x 27 mm
- Weight: approx. 85 g
