Overview
The 3ctest LCG 50A impulse current simulator is featured with high system integration, intelligent control and easy operation. Output can be divided into multiple levels by different combination of main circuit units to widen output range. Setting test requirements on parameters setting page, test can be conducted with one button.
As per
- IEC 61643-1
- GB18802.1-2002
- GB/T 16896.2
- GB/T 11032
- YD-T 5098
| General Data | ||
| Power supply | AC220V ± 10%, 50/60Hz 60A | |
| Temperature | 10—40° | |
| Humidity | 35%-85%RH?no condensation? | |
| Ground resistance | No more than 0.5Ω | |
| Technical Parameters | ||
| Output waveform | 10/350μs±10% current wave | |
| Output peak current | 1kA?50kA±10? | |
| Voltage polarity | +/-,?Switch automatically? | |
| Charging time | Less than 80%: full within 60s More than 80%: full within 120s | |
| Instability of charging voltage | Less than 1% | |
| Trigger mode | Automatic or manual, single trigger available | |
| Trigger malfunction rate | Less than 1% | |
| Trigger range | 100% rated charging voltage | |
| Phase angle | 0?360°Step 1° | |
| Phase control resolution | ±3° | |
| Optional Accessories | ||
| Name | Specification | Brand |
| Current measurement coil | TR1330 100kA | HILOK |
| Residual voltage divider | CF-5 5kV | HILOK |
| Attenuator | A10 50 ohm | HILOK |
| Measurement and analysis software | MAS3000, including fiber-optic module | 3ctest |
| Oscilloscope | MDO3012 | Tektronix |
| Decoupling network mains | Single phase AC0?500V 5A 3kW, isolated mains | |
