Overview
The Biaxial Field Probe Positioner FPP 2.3/1.5 is specifically designed for remote-controlled measurements at defined vertical areas. The system allows automatic measurements of the field homogeneity according to EN61000-4-3 and IEC 61000-4-3.
Limit switches and the general mechanical design ensures reliable system operation.
The FPP 2.3/1.5, with the exception of the drive unit, is fabricated from plastic (PVC and reinforced fibreglass). Metal parts are located only in the base plate and the drive mechanism (max. 0.3 m above ground level).
The IEEE 488.2 (GPIB) bus provides an additional control option for all functions, when operated with the MCU or NCD Controller.
| Technical Data | |
| Field Probe height adjustment from | 0.8 – 2.3 m |
| Overall height | 2.7 m |
| Horizontal range | 1.5 m |
| Overall length | 2.3 m |
| Load Capability | 3 kg |
| Material | Plastics (PVC and reinforced fibreglass) |
| Cross-section carrier tubes | 60 mm x 60 mm |
| Rail width | 650 mm |
| Positioning speed adjustable between | 2.0 – 12.0 cm/s |
| Positioning accuracy | +/- 1 cm |
| Motors | Brushless DC motors 200 W |
| Interference suppression | 20 dB under limits EN 55022 class B |
| Current consumption | max. 2A |
| Voltage | 208-230 VAC, 50/60 Hz, single phase |
| Discharge current | 25mA per drive unit (higher in the moment when powering on) |
| Control cable | Fibre optic lines |
| Remote control via | IEEE interface |
| Antenna support drive | 2 toothed belts |
| Material of toothed belts | Kevlar reinforced (non-metallic) |
| Temperature range | +10 °C...+35 °C |
| Total weight | approx. 40 kg |
| Accessories | Interface to MCU/NCD Controller 1.5 m power supply cable 5m & 10m Fibre optic cable Service manual |
