MIL-STD-461 CS116

(Showing 7 of 7)

The EMC Shop stocks test equipment to perform MIL-STD-461 CS116 testing.

MIL-STD-461 CS116 Purpose

Conducted susceptibility, damped sinusoidal transients on cables and power leads.

 

This requirement is applicable from 10 kHz to 100 MHz for all interconnecting cables, including power cables, and individual high side power leads. Power returns and neutrals need not be tested individually. This test procedure is used to verify the ability of the EUT to withstand damped sinusoidal transients coupled onto EUT associated cables and power leads.

MIL-STD-461 CS116 Test Setup

MIL-STD-461 CS116 Test Setup

The test equipment required:

  1. Damped sinusoid transient generator, ≤ 100 ohm output impedance
  2. Current injection probe
  3. Oscilloscope or measurement receiver
  4. Calibration Fixture
  5. Current Probe
  6. Attenuator
  7. RF Loads
  8. LISNs

Rent Now

Start testing and debugging your EUT to MIL-STD-461 CS116 conducted susceptibility requirements.

Contact

MIL-STD-461 CS116 Test Equipment, Systems & Solutions

Connect with The EMC Shop

Our experienced staff can help you with applications, purchase and rental options.

Contact Form